Ceramic fiber shaped components are widely used in the sound insulation, insulation, fire prevention, and other aspects of lightweight walls, playing a crucial role in today's life. So what should we pay attention to when constructing Ceramic fiber shaped parts on equipment?
1. When laying Ceramic fiber shaped parts, the veneer should face the indoor side, perpendicular to the purlin, and leave about 20 centimeters of felt at one side of the eaves. Use a dedicated fixture or double-sided tape to fix it on the outermost purlin.
2. When unwinding, ensure alignment and tension, lay it on the other side of the eaves, leave an additional 20 centimeters of roll felt, and fix it on the outermost purlin with a dedicated fixture or double-sided tape.
3. The two rolls of cotton are connected together by binding them with a stapler on the veneer flash.
4. The equipment roof color steel plate, remove the special fixture at the eaves, and use the reserved 20cm veneer to trim the edges with glass wool.
5. Pay attention to the tension, alignment, and tight seams between rolls of Ceramic fiber shaped parts. When longitudinal overlap is required, the lap joint should be installed at the purlin.
6. According to engineering requirements, in order to avoid the occurrence of cold insulation bridges, it is possible to consider placing some hard insulation materials on the purlins